Belt Sleeve
These sleeves secure the loose end of a belt to itself.
Specs
| material | Aluminum |
| Surface finish | Sand blasted and clear anodized |
| Price | $0.50 |
| Quantity |
Genesis - 6
Genesis XL - 6 |
| CAD model | Onshape |
| Purchase | The FarmBot Shop |
| internal-part-name | Belt Sleeve |
| rev | A |
| vendor | LDO |
| cost | $0.25 |
Component tests
| Test | Description | Target | Tolerance |
|---|---|---|---|
| Inner width | Measure using digital calipers. | 7.5mm | +/- 0.1mm |
| Inner height | Measure using digital calipers. | 2.15mm | +/- 0.05mm |
| Belt fit | Assemble the belt sleeve with a belt and belt clip. | The belt sleeve should fit snugly over the two belt sections and provide adequate holding force. | N/A |
| Outer width | Measure using digital calipers. | 10mm | +/- 0.2mm |
| Outer height | Measure using digital calipers. | 5mm | +/- 0.2mm |
| Length | Measure using digital calipers. | 10mm | +/- 0.5mm |
| Material | Ensure the material is aluminum and will not rust by holding a magnet to the part. | Aluminum (no magnetic attraction) | N/A |
| Sandblasting | Inspect for thorough sandblasting coverage. | 100% | -1% |
| Anodization | Inspect for thorough annodization coverage. | 100% | -1% |
| Deburred | Inspect for burrs. | No burrs | 0 |