Jumper Link
These connect the Grounded electronic pin to the Digital In pin, allowing FarmBot to detect when a tool has been mounted or dismounted correctly.
Specs
| material | Aluminum |
| thickness | 1mm |
| hole sizes | M3 |
| Price | $0.50 |
| Quantity |
Genesis - 4
Genesis XL - 4 |
| CAD model | Onshape |
| Purchase | The FarmBot Shop |
| internal-part-name | Jumper Link |
| rev | A |
| vendor | LDO |
| cost | $0.25 |
| notes | Pre-assembled in Seeder, Watering Nozzle, Weeder, and Soil Sensor Tools |
Component tests
| Test | Description | Target | Tolerance |
|---|---|---|---|
| Hole size | Measure the size of the holes using digital calipers. | 3.25mm | +/- 0.1mm |
| Fit | Assemble a jumper link into a tool using M3 screws and locknuts according to the FarmBot system design. | Part should fit without interference | N/A |
| Thickness | Measure the thickness using digital calipers. | 1mm | +/- 0.2mm |
| Material | Ensure the material will not rust by holding a magnet to the part. | Aluminum (no magnetic attraction) | N/A |
| Electrical conductivity | Connect an ohm meter to both ends of a jumper link. | Less than 1 ohm | N/A |