Cross-Slide
Documentation and Assembly Instructions for the FarmBot Genesis Cross-Slide
Component List
To prepare for assembly, gather all the components from the table below and lay them out in a logical manner. To complete the assembly in the next pages, you will also need the following tools:
- 3mm hex (allen) wrench
- 8mm wrench
Note: Not all required parts are shown in this image.
Qty. | Component |
---|---|
1 | Cross-Slide Plate |
2 | M3 x 5mm Setscrews |
4 | M5 x 16mm Screws |
12 | M5 x 30mm Screws |
6 | M5 x 6mm Spacers |
6 | 6mm Eccentric Spacers |
14 | M5 Washers |
16 | M5 Locknuts |
1 | Horizontal Motor Housing |
1 | Long Cable Carrier Mount |
12 | Complete V-Wheels (one polycarbonate wheel, two 16 x 5 x 5mm ball bearings, and one 10 x 5 x 1mm shim) |
1 | Leadscrew Block |
1 | NEMA 17 Stepper Motor and Rotary Encoder with 2500mm length cables |
1 | 20 tooth GT2 Pulley |
2 | Belt Clip Plates |
1 | Y-Axis Belt |
2 | M3 x 10mm Screws |
Change Log
- Horizontal motor housing has been completely re-designed to better protect the ends of the motor and the rotary encoder from rain.
- Flipped the orientation of the long drag chain mount and added a gusset for support.
- Increased the size of the slot on the cross-slide for the motor and encoder wires to be passed through more easily.
- Increased the tolerance of the eccentric spacer holes on the cross-slide plate.
- Switched to button head M5 screws.
- Increased the cross-slide plate width by 10mm to accommodate the larger z-axis cable carrier and adjusted the mounting holes accordingly.
- Added a V-wheel with eccentric spacer to the middle of the bottom edge of the cross-slide plate for added strength in the connection with the gantry main beam.
Room for Improvement
- The Z axis cable carrier mounting holes could be changed to a slot to allow for more flexibility with which cable carrier to use, and where exactly it is mounted on the plate
- Explore a bent metal plate version of the long drag chain mount