• Step 1: Attach the RAMPS Shield to the Power Supply
• Step 2: Attach the DC/DC converter from the RAMPS Shield to the Pi
• Step 3: Plug in the Stepper Motors and Rotary Encoders
• Step 4: Plug in the UTM Cable’s Connectors
• Step 5: Connect the peripherals
• Step 6: Plug in the Power Supply

Step 1: Attach the RAMPS Shield to the Power Supply

Use 2-16 stranded wire (two stranded wires of 16 gauge) to connect the power supply to the RAMPS shield. One wire should connect the ground output of the power supply to the negative/ground input on the RAMPS shield. The other wire should connect the +12V output of the power supply to the positive input on the RAMPS shield.

Step 2: Attach the DC/DC converter from the RAMPS Shield to the Pi

Step 3: Plug in the Stepper Motors and Rotary Encoders

Detailed instructions coming soon

Step 4: Plug in the UTM Cable’s Connectors

Detailed instructions coming soon

Step 5: Connect the peripherals

Detailed instructions coming soon

Step 6: Plug in the Power Supply

Before plugging in...

Double check all of your connections, component orientations, and ensure there are not any exposed wires that could short circuit or cause electrical shock.

The mark of success

If all has gone well, your Raspberry Pi should boot up, there should be no smoke, and you should revel in the little blinking red and green lights!