• Step 1: Purchase components
• Step 2: Connect the lights to the RAMPS shield
• Step 3: Mount or route the lights wherever desired
• Step 4: Use the lights
  • Method 1: Manually control the lights with the peripherals widget
  • Method 2: Systematically use the lights in your sequences and regimens

Want to light up your FarmBot at night so you can more easily harvest dinner-time veggies? Or maybe you want to experiment with growth rates by using specialized grow lights? Whatever the reason you want to have lights on your FarmBot, we’ll show you how to do it in this easy tutorial.

Step 1: Purchase components

Component	Recommended Supplier	Cost
Waterproof 12V Flexible LED Strip Lights	Amazon	$10.15

Step 2: Connect the lights to the RAMPS shield

FarmBot’s RAMPS shield provides multiple 12V outputs which can be used to power the LED lights. Strip 5mm of insulation off of the red and black wires coming from the LED strip.

Attach the wires to one of the RAMPS shield 12V outputs, making sure the red wire is hooked up to the positive output, while the black wire is hooked up to the negative output. Take note of the pin number you are connecting to as it will be used to control the lights from the web app later.

Step 3: Mount or route the lights wherever desired

The LED strip we recommend purchasing is easily routed through the horizontal cable carrier supports as shown. This configuration will cast light down from the gantry onto your plants. If you would like to mount your lights elsewhere, you can use the included adhesive backing, zipties, double sided foam tape, or other means to secure the lights as desired.

Step 4: Use the lights

In general there are two ways to use your newly installed LED lights:

Method 1: Manually control the lights with the peripherals widget

From the FarmBot Web App, navigate to the Controls page. Click the Edit button in the header of the Peripherals widget. Create a new peripheral named “Lights” and assign it the pin number that you hooked the LED wires to on the RAMPS shield. Then click the Save button in the widget header and you will now have a shiny new toggle switch to operate your lights!

Method 2: Systematically use the lights in your sequences and regimens

Because your lights are hooked up to a pin on the Arduino, you can easily create sequences that utilized the lights. Simply add a Write Pin step into your sequence to turn the lights on with a pin value of “1” and off with a pin value of “0”. Make sure you set the pin mode to “0” and the pin number to whichever pin number you hooked up the wires to on the RAMPS shield.