Page Contents

Step 1: Slide on a belt sleeve

Slide a belt sleeve onto the belt.

Screen Shot 2020-02-17 at 12.45.05 PM.png

Step 2: Route the belt through the clip

Route the belt down through the slot in the belt clip and then wrap the belt back under itself. The teeth from the short end of the belt should engage with the teeth on the long end.

Screen Shot 2020-02-17 at 12.50.40 PM.png

Step 3: Secure the belt with the sleeve

Slide the belt sleeve over both ends of the belt. This may take a small bit of force and some wiggling.

Screen Shot 2020-02-17 at 12.54.07 PM.png

Step 4: Mount the clip

Mount the clip to the end of an extrusion with a 20mm nut bar and M5 x 10mm screws.

Screen Shot 2020-02-17 at 12.58.35 PM.png