Toolbays
Documentation and assembly instructions for the FarmBot Genesis toolbays
FarmBot Genesis comes with two toolbays that hold three tools, seed bins, or seed trays each. These simple hardware components act as holsters for your tools and are shaped in such a way that FarmBot can automatically mount and dismount tools for the task at hand.
15 minutes
This is the estimated time it will take to install both toolbays
Step 1: Gather the parts and tools
Gather necessary parts from the table below and lay them out in a logical manner. To complete the assembly, you will also need the following tools:
| Qty. | Component |
|---|---|
| 2 | Toolbays |
| 12 | 25mm Wood Screws |
Step 2: Attach a toolbay to the supporting infrastructure
Position and attach a toolbay to your supporting infrastructure using six 25mm wood screws.
Orientation matters
Keep in mind that FarmBot’s tools are designed to be mounted by the UTM in only one orientation so that the electrical pins and magnets match up. The text on the front of the tools should line up with the FarmBot logo on the front of the UTM cover. Because tools can only slot into the tool bay in two orientations, you must orient your tool bay with the longer edge parallel to the gantry main beam.
Note: It is possible to orient the long edge parallel with the tracks, though that would require changing the orientation of the UTM by 90 degrees as well.
Within reach and squared up
Ensure that you mount the tool bay in a location that FarmBot’s UTM can get to. Keep in mind that the UTM needs to be able to slide tools all the way into the bay, all the way out, and be able to mount and dismount tools from above. Make sure you verify this for each of the tool bay’s slots.
The toolbay must also be square with the rest of FarmBot (all three axes) in order for tools to be properly mounted and dismounted. Use shims or extra washers to make fine adjustments to the angle of your toolbays if needed. We added small notches to the sides of the toolbays to help you line them up with your supporting infrastructure. Of course, you can only use these if your supporting infrastructure is square and properly aligned.
Last, keep in mind the size of the tools and ensure that there is adequate room underneath and in front of your toolbays for proper mounting and dismounting.
Step 3: Repeat for the second toolbay
Two toolbays not enough?
If you are interested in using more than six tools and seed containers at once, you will need to purchase or make more toolbays. Check out our online shop to purchase more.
Step 4: Insert the tools
Place your tools and seed containers in any slot you want. Just remember that you will need to log in to the web app and let FarmBot know what tool is where!
