Remove all of the snap-in tabs from the x-axis cable carrier. Note that the x-axis and y-axis cable carriers are the same length, but the x-axis cable carrier is narrower than the y-axis one.
There is only one orientation that the x-axis cable carrier mounts to the gantry and tracks, and it is determined by the orientation of the end pieces. Lay the cable carrier onto the track’s horizontal cable carrier supports to ensure you have it correctly oriented. Do not attach it at this time.
Lay the x-axis water tube and the power supply cable into the open x-axis cable carrier. The gray connector of the power supply cable should extend beyond the gantry-mounted cable carrier end by about 50cm so that it can plug into the Farmduino. The water tube should be extended the same distance.
Organization is important!
When laying the cable and tube in the carrier, ensure that they do not criss-cross over each other. If they do, you will have trouble snapping in the tabs and you risk compressing the tube and preventing water flow.
Snap in three cable carrier tabs at both ends of the cable carrier, and a few more spread throughout the middle of the cable carrier so the cable and tube stay in place. You do not want to snap in all of the tabs at this time because that will make it difficult to make adjustments if needed.
Once everything is situated well, snap-in the remaining cable carrier tabs, ensuring that you maintain organization of the cable and tube.
Not easy to adjust
Once you snap-in the remaining tabs, it will become difficult to adjust the cable and tube without removing many of the tabs first. Make sure everything is in place before you make a bunch of extra work for yourself.