The seeder tool works by using a vacuum pump to suction-hold a single seed at the end of a needle.
Pre-assembled for your convenience
As of the v1.6 hardware release, the seeder tool comes pre-assembled. In the next steps we’ll hook up the rest of FarmBot’s vacuum system.
FarmBot comes with different luer lock needle sizes so that you can experiment and find the best needle for your needs.
|Size||Gauge||Inner Diameter||Good for|
|Large||16||1.35mm (0.053”)||Large seeds (eg: pumpkin)|
|Medium||19||0.83mm (0.032”)||Most seeds|
|Small||22||0.48mm (0.019”)||Small seeds (eg: lettuce)|
Once you’ve selected a needle, attach it to the luer lock adapter with a quarter turn. At any time you can quickly swap the needle out for another size or replace a damaged one.
Slide one of the vacuum tubes onto the inlet barb of the vacuum pump. The inlet will be marked with an arrow pointing into the pump. The inlet may be on the left or the right side of the pump depending on when your kit was purchased. Please refer to the arrows on your pump to ensure the tube is connected correctly.
Is your seeder blowing?
If you find during testing that there is air blowing out of the seeder tool, you may try connecting the tube to the other port. We use parts from different suppliers and the vacuum pump configuration may be different on your model.
Connect the vacuum pump cable to the vacuum pump terminals. The black wire should be connected to
GND (the terminal on the right), the white wire should be connect to
24V (the middle terminal), and the clear wire should be connected to
PE (the terminal on the left at a 90-degree angle from the others). In a few steps from now, you will connect the other end of the cable to the Farmduino.
Attach the seed trough holder to the seed trough holder mount plate using two M5 x 30mm screws and M5 flange locknuts. Then mount the assembly to the left gantry column using a 40mm nut bar and two M5 x 10mm screws.
We offer the following types of seed containers, each optimized for different purposes.
The seed bins are for holding large amounts of one type of seed. This is best used when planting many plants of the same crop, for example: when growing microgreens. To use a seed bin, simply slide it into the toolbay and fill it with seeds. Then run a planting sequence from the web app with the corresponding seed bin sequence and location.
If desired, you can mix a variety of seed types into one seed bin and have FarmBot plant whatever it happens to grab. Keep in mind though that FarmBot will have no way of knowing which seeds it grabs, so only use this technique when you will be taking care of all those plants identically. An example for this again might be when growing microgreens - you can grow three different types in the same area at the same time, all in the same way, without having to do three planting sequences or otherwise treat them differently.
The seed trays have 16 small area for holding seeds. They are best used when planting many different crops, and when the number of seeds per hole needs to be strictly controlled.
The seed troughs are small seed containers that are stored in the seed trough holder, which is mounted on the gantry. This allows FarmBot to bring seeds with it along the x-axis, reducing the time to sow an entire bed.