||Measure the length of the belt using a measuring tape.
||See BOM spec.
||Measure the width of the belt using digital calipers.
||Lay the belt into the V-slot of an extrusion.
||The belt should pass through the narrowest section and lay flat in the bottom of the slot.
||Measure the distance between one tooth and another one 50 teeth away using digital calipers, then divide by 50.
||+/- 0.02mm (1%)
||Engage the belt to a GT2 pulley.
||The belt should fully engage with the pulley’s teeth.
||Measure the thickness of the belt using digital calipers.
|Belt sleeve fit
||Assemble the belt to a belt clip and secure with a belt sleeve.
||The belt sleeve should fit snugly over the two belt sections and provide adequate holding force.
||Tie a belt to a fixture 1.5m or more off the ground. Mark the belt just below the knot and then add a second mark exactly 1000mm below the first. Hang a 10kg weight from the belt (below the 1000mm mark) and measure the distance between the two marks.
||+ 10mm (1%)
||Use a tensile testing machine to measure the equivalent hung weight at which the belt will break.
||Inspect the belt for any discoloration or markings
||Black, no markings.